The X9C102, X9C103, X9C104, X9C503 are Intersils’

digitally controlled (XDCP) potentiometers. The device

consists of a resistor array, wiper switches, a control section,

and non-volatile memory. The wiper position is controlled by

a three-wire interface.

The potentiometer is implemented by a resistor array

composed of 99 resistive elements and a wiper switching

network. Between each element and at either end are tap

points accessible to the wiper terminal. The position of the

wiper element is controlled by the CS, U/D, and INC inputs.

The position of the wiper can be stored in non-volatile

memory and then be recalled upon a subsequent power-up

operation.

The device can be used as a three-terminal potentiometer or

as a two-terminal variable resistor in a wide variety of

applications ranging from control to signal processing to

parameter adjustment.

Features

? Solid-State Potentiometer

? Three-Wire Serial Interface

? 100 Wiper Tap Points

- Wiper Position Stored in Non-volatile Memory and

Recalled on Power-up

? 99 Resistive Elements

- Temperature Compensated

- End-to-End Resistance, ±20

- Terminal Voltages, ±5V

? Low Power CMOS

- VCC = 5V

- Active Current, 3mA max.

- Standby Current, 750μA max.

? High Reliability

- Endurance, 100,000 Data Changes per Bit

- Register Data Retention, 100 years

? X9C102 = 1kΩ

? X9C103 = 10kΩ

? X9C503 = 50kΩ

? X9C104 = 100kΩ

? Packages

- 8 Ld SOIC

- 8 Ld PDIP

? Pb-Free Available (RoHS Compliant)