TDA10045中文資料飛利浦?jǐn)?shù)據(jù)手冊PDF規(guī)格書

GENERAL DESCRIPTION

The TDA10045H is a single-chip channel receiver for 2 and 8 kbytes COFDM modulated signals based on the ETSI specification (ETSI 300-744). The device interfaces directly to an IF signal, which could be either 1st or 2nd IF and integrates a 10-bit Analog-to-Digital Converter (ADC), a Numerically Controlled Oscillator (NCO) and a Phase-Locked Loop (PLL), simplifying external logic requirements and limiting system costs.

FEATURES

? 2 and 8 kbytes Coded Orthogonal Frequency Division Multiplexer (COFDM) demodulator (fully DVB-T compliant: ETSI 300-744)

? All modes supported, including hierarchical modes

? Fully automatic transmission parameters detection (including Fast Fourier Transformer (FFT) size and guard interval)

? Digital Signal Processor (DSP) based synchronization (software can be upgraded on the fly)

? No extra-host software required

? On-chip 10-bit Analog-to-Digital Converter (ADC)

? 2nd or 1st IF variable analog input

? Only fundamental crystal oscillator required (4 MHz typical ±100 ppm)

? 6, 7 and 8 MHz channels with the same crystal

? Pulse killer algorithm to protect against impulse noise

? Digital frequency correction (±90 kHz)

? Frequency offset (±1/6 MHz) automatic estimator to speed-up the scan

? RF tuner input power measurement

? Parallel or serial transport stream interface

? BER measurement (before and after Viterbi decoder)

? Signal-to noise ratio estimation

? Constellation, CSI and channel frequency response outputs

? TPS bits I2C-bus readable (including spare ones)

? Controllable dedicated I2C-bus for the tuner (5 V tolerant)

? 3 low frequency spare DACs and 2 spare inputs

? CMOS 0.2 μm technology.

APPLICATIONS

? DVB-T fully compatible

? Digital data transmission using COFDM modulation.