P87C58X2集成電路（IC）的微控制器規(guī)格書PDF中文資料

DESCRIPTION

The Philips microcontrollers described in this data sheet are

high-performance static 80C51 designs incorporating Philips’

high-density CMOS technology with operation from 2.7 V to 5.5 V.

They support both 6-clock and 12-clock operation.

The P8xC31X2/51X2 and P8xC32X2/52X2/54X2/58X2 contain

128 byte RAM and 256 byte RAM respectively, 32 I/O lines, three

16-bit counter/timers, a six-source, four-priority level nested interrupt

structure, a serial I/O port for either multi-processor

communications, I/O expansion or full duplex UART, and on-chip

oscillator and clock circuits.

In addition, the devices are low power static designs which offer a

wide range of operating frequencies down to zero. Two software

selectable modes of power reduction — idle mode and power-down

mode — are available. The idle mode freezes the CPU while

allowing the RAM, timers, serial port, and interrupt system to

continue functioning. The power-down mode saves the RAM

contents but freezes the oscillator, causing all other chip functions to

be inoperative. Since the design is static, the clock can be stopped

without loss of user data. Then the execution can be resumed from

the point the clock was stopped.

FEATURES

? 80C51 Central Processing Unit

– 4 kbytes ROM/EPROM (P80/P87C51X2)

– 8 kbytes ROM/EPROM (P80/P87C52X2)

– 16 kbytes ROM/EPROM (P80/P87C54X2)

– 32 kbytes ROM/EPROM (P80/P87C58X2)

– 128 byte RAM (P80/P87C51X2 and P80C31X2)

– 256 byte RAM (P80/P87C52/54X2/58X2 and P80C32X2)

– Boolean processor

– Fully static operation

– Low voltage (2.7 V to 5.5 V at 16 MHz) operation

? 12-clock operation with selectable 6-clock operation (via software

or via parallel programmer)

? Memory addressing capability

– Up to 64 kbytes ROM and 64 kbytes RAM

? Power control modes:

– Clock can be stopped and resumed

– Idle mode

– Power-down mode

? CMOS and TTL compatible

? Two speed ranges at VCC = 5 V

– 0 to 30 MHz with 6-clock operation

– 0 to 33 MHz with 12-clock operation

? PLCC, DIP, TSSOP or LQFP packages

? Extended temperature ranges

? Dual Data Pointers

? Security bits:

– ROM (2 bits)

– OTP (3 bits)

? Encryption array - 64 bytes

? Four interrupt priority levels

? Six interrupt sources

? Four 8-bit I/O ports

? Full-duplex enhanced UART

– Framing error detection

– Automatic address recognition

? Three 16-bit timers/counters T0, T1 (standard 80C51) and

additional T2 (capture and compare)

? Programmable clock-out pin

? Asynchronous port reset

? Low EMI (inhibit ALE, slew rate controlled outputs, and 6-clock

mode)

? Wake-up from Power Down by an external interrupt.