LPC1837JET100

High Performance 32-bit Microcontroller (MCU) based on ARM Cortex-M3 Core; ? Processor core? Arm Cortex-M3 processor, running at CPU frequencies of up to 180 MHz\n? Arm Cortex-M3 built-in Memory Protection Unit (MPU) supporting eight regions\n? Arm Cortex-M3 built-in Nested Vectored Interrupt Controller (NVIC)\n? Non-maskable Interrupt (NMI) input\n? JTAG and Serial Wire Debug, serial trace, eight breakpoints, and four watch points\n? Enhanced Trace Module (ETM) and Enhanced Trace Buffer (ETB) support\n? System tick timer\n? On-chip memory? Up to 1 MB on-chip dual bank flash memory with flash accelerator\n? 16 kB on-chip EEPROM data memory\n? 136 kB SRAM for code and data use\n? Multiple SRAM blocks with separate bus access\n? 64 kB ROM containing boot code and on-chip software drivers\n? 64 bit of One-Time Programmable (OTP) memory for general-purpose use\n? Clock generation unit? Crystal oscillator with an operating range of 1 MHz to 25 MHz\n? 12 MHz internal RC oscillator trimmed to 2 % accuracy over temperature andvoltage (1 % accuracy for Tamb = 0 °C to 85 °C)\n? Ultra-low power RTC crystal oscillator\n? Three PLLs allow CPU operation up to the maximum CPU rate without the need fora high-frequency crystal. The second PLL can be used with the High-speed USB,the third PLL can be used as audio PLL\n? Clock output\n? Configurable digital peripherals? State Configurable Timer (SCT) subsystem on AHB\n? Global Input Multiplexer Array (GIMA) allows to cross-connect multiple inputs andoutputs to event driven peripherals like timers, SCT, and ADC0/1\n? Serial interfaces? Quad SPI Flash Interface (SPIFI) with 1-, 2-, or 4-bit data at rates of up to52 MB per second\n? 10/100T Ethernet MAC with RMII and MII interfaces and DMA support for highthroughput at low CPU load. Support for IEEE 1588 time stamping/advanced timestamping (IEEE 1588-2008 v2)\n? One High-speed USB 2.0 Host/Device/OTG interface with DMA support andon-chip high-speed PHY (USB0)\n? One High-speed USB 2.0 Host/Device interface with DMA support, on-chipfull-speed PHY and ULPI interface to an external high-speed PHY (USB1)\n? USB interface electrical test software included in ROM USB stack\n? Four 550 UARTs with DMA support: one UART with full modem interface; oneUART with IrDA interface; three USARTs support UART synchronous mode and asmart card interface conforming to ISO7816 specification\n? Up to two C_CAN 2.0B controllers with one channel each. Use of C_CAN controllerexcludes operation of all other peripherals connected to the same bus bridge\n? Two SSP controllers with FIFO and multi-protocol support. Both SSPs with DMAsupport\n? One Fast-mode Plus I2C-bus interface with monitor mode and with open-drain I/Opins conforming to the full I2C-bus specification. Supports data rates of up to1 Mbit/s\n? One standard I2C-bus interface with monitor mode and standard I/O pins\n? Two I2S interfaces with DMA support, each with one input and one output\n? Digital peripherals? External Memory Controller (EMC) supporting external SRAM, ROM, NOR flash,and SDRAM devices\n? LCD controller with DMA support and a programmable display resolution of up to1024H x 768V. Supports monochrome and color STN panels and TFT color panels;supports 1/2/4/8 bpp Color Look-Up Table (CLUT) and 16/24-bit direct pixelmapping\n? SD/MMC card interface\n? Eight-channel General-Purpose DMA controller can access all memories on theAHB and all DMA-capable AHB slaves\n? Up to 164 General-Purpose Input/Output (GPIO) pins with configurablepull-up/pull-down resistors\n? GPIO registers are located on the AHB for fast access. GPIO ports have DMAsupport\n? Up to eight GPIO pins can be selected from all GPIO pins as edge and levelsensitive interrupt sources\n? Two GPIO group interrupt modules enable an interrupt based on a programmablepattern of input states of a group of GPIO pins\n? Four general-purpose timer/counters with capture and match capabilities\n? One motor control PWM for three-phase motor control\n? One Quadrature Encoder Interface (QEI)\n? Repetitive Interrupt timer (RI timer)\n? Windowed watchdog timer\n? Ultra-low power Real-Time Clock (RTC) on separate power domain with 256 bytesof battery powered backup registers\n? Event recorder with three inputs to record event identification and event time; canbe battery powered\n? Alarm timer; can be battery powered\n? Analog peripherals? One 10-bit DAC with DMA support and a data conversion rate of 400 kSamples/s\n? Two 10-bit ADCs with DMA support and a data conversion rate of 400 kSamples/s.Up to eight analog channels total. Each analog input is connected to both ADCs\n? Unique ID for each device\n? Power? Single 3.3 V (2.2 V to 3.6 V) power supply with on-chip internal voltage regulator forthe core supply and the RTC power domain\n? RTC power domain can be powered separately by a 3 V battery supply\n? Four reduced power modes: Sleep, Deep-sleep, Power-down, and Deeppower-down\n? Processor wake-up from Sleep mode via wake-up interrupts from variousperipherals\n? Wake-up from Deep-sleep, Power-down, and Deep power-down modes viaexternal interrupts and interrupts generated by battery powered blocks in the RTCpower domain\n? Brownout detect with four separate thresholds for interrupt and forced reset\n? Power-On Reset (POR)\n? Available in LQFP208, LBGA256, LQFP144, and TFBGA100 packages\n;

The LPC185x/3x/2x/1x are Arm Cortex-M3 based microcontrollers for embeddedapplications. The Arm Cortex-M3 is a next generation core that offers systemenhancements such as low power consumption, enhanced debug features, and a highlevel of support block integration.\nThe LPC185x/3x/2x/1x operate at CPU frequencies of up to 180 MHz. The ArmCortex-M3 CPU incorporates a 3-stage pipeline and uses a Harvard architecture withseparate local instruction and data buses as well as a third bus for peripherals. The ArmCortex-M3 CPU also includes an internal prefetch unit that supports speculativebranching.\nThe LPC185x/3x/2x/1x include up to 1 MB of flash and 136 kB of on-chip SRAM, 16 kB ofEEPROM memory, a quad SPI Flash Interface (SPIFI), a State Configurable Timer (SCT)subsystem, two High-speed USB controllers, Ethernet, LCD, an external memorycontroller, and multiple digital and analog peripherals.\n

恩XP

LPC1837JET100

Errata sheet LPC185x, LPC183x, LPC182x, LPC181x flash-based devices

ETC

LPC1837JET100

32-bit ARM Cortex-M3 MCU; up to 1 MB flash and 136 kB

PHI

LPC1837JET100

32-bit ARM Cortex-M3 MCU; up to 1 MB flash and 136 kB SRAM; Ethernet, two High-speed USB, LCD, EMC

ETC