HDC3020開發板套件編程器的評估板-傳感器規格書PDF中文資料

1 Features

? AEC-Q100 qualified for automotive applications

– Temperature Grade 1: –40°C to 125°C

– Device HBM ESD Classification Level 2

– Device CDM ESD Classification Level C4

? Functional Safety-Capable

– Documentation to aid functional safety system

design

? Relative humidity (RH) sensor:

– Operating range: 0 to 100

– Accuracy: ±0.5 typical

– Offset Error Correction: reduces offset to return

device to within accuracy specification

– Long-term drift: 0.19RH/yr

– Condensation protection with integrated heater

? Temperature sensor:

– Operating range: –40°C to 125°C

– Accuracy: ±0.1°C typical

? NIST traceability: relative humidity & temperature

? Low power: average current 0.4 μA

? I2C interface compatibility up to 1-MHz speeds

– Four selectable I2C addresses

– Data protection through CRC checksum

? Supply voltage: 1.62 V to 5.50 V

? Available auto measurement mode

? Programmable interrupts

? Programmable RH and Temp measurement offset

? Factory-installed polyimide tape assembly cover

? Factory-installed IP67 rated environmental cover

? WSON package with wettable flanks options

2 Applications

? Automotive HVAC control module

? Automotive HVAC sensor - air quality

? Automotive Particulate Matter PM2.5

? Battery Management Systems

? On Board Charging

? Automotive Camera

3 Description

The HDC302x-Q1 is an integrated capacitive based

relative humidity (RH) and temperature sensor. It

provides high accuracy measurements over a wide

supply range (1.62 V – 5.5 V), along with ultra-low

power consumption in a compact 2.5-mm × 2.5-mm

package. Both the temperature and humidity sensors

are 100 tested and trimmed on a production setup

that is NIST traceable and verified with equipment that

is calibrated to ISO/IEC 17025 standards.

Offset Error Correction reduces RH sensor offset due

to aging, exposure to extreme operating conditions,

and contaminants to return device to within accuracy

specifications. For battery IoT applications, auto

measurement mode and ALERT feature enable low

system power by maximizing MCU sleep time. There

are four different I2C addresses that support speeds

up to 1 MHz. A heating element is available to

dissipate condensation and moisture.

The HDC3020-Q1 is an open cavity package without

protective cover. Two device variants have a cover

option to protect the open cavity RH sensor:

HDC3021-Q1 and HDC3022-Q1. HDC3021-Q1 has

removable protective tape to allow conformal coatings

and PCB wash. HDC3022-Q1 has a permanent IP67

filter membrane to protect against dust, water and

PCB wash. All 3 package variants have wettable

flanks option.