DRV8353M

具有電流分流放大器和擴(kuò)展溫度范圍的最大 102V 三相智能柵極驅(qū)動(dòng)器; ? 9 to 100-V, Triple half-bridge gate driver \n? Extended TA operation -55 °C to 125 °C \n? Optional triple low-side current shunt amplifiers\n \n? Smart gate drive architecture \n? Adjustable slew rate control for EMI performance\n? VGS handshake and minimum dead-time insertion to prevent shoot-through\n? 50-mA to 1-A peak source current\n? 100-mA to 2-A peak sink current\n? dV/dt mitigation through strong pulldown\n \n? Integrated gate driver power supplies \n? High-side doubler charge pump For 100% PWM duty cycle control\n? Low-side linear regulator\n \n? Integrated triple current shunt amplifiers \n? Adjustable gain (5, 10, 20, 40 V/V)\n? Bidirectional or unidirectional support\n \n? 6x, 3x, 1x, and independent PWM modes \n? Supports 120° sensored operation\n \n? SPI or hardware interface available\n? Low-power sleep mode (20 μA at VVM = 48-V)\n? Integrated protection features \n? VM undervoltage lockout (UVLO)\n? Gate drive supply undervoltage (GDUV)\n? MOSFET VDS overcurrent protection (OCP)\n? MOSFET shoot-through prevention\n? Gate driver fault (GDF)\n? Thermal warning and shutdown (OTW/OTSD)\n? Fault condition indicator (nFAULT);

The DRV8353M family of devices are highly-integrated gate drivers for three-phase brushless DC (BLDC) motor applications. These applications include field-oriented control (FOC), sinusoidal current control, and trapezoidal current control of BLDC motors. The device variants provide optional integrated current shunt amplifiers to support different motor control schemes and a buck regulator to power the gate driver or external controller.\n\nThe DRV8353M uses smart gate drive (SGD) architecture to decrease the number of external components that are typically necessary for MOSFET slew rate control and protection circuits. The SGD architecture also optimizes dead time to prevent shoot-through conditions, provides flexibility in decreasing electromagnetic interference (EMI) by MOSFET slew rate control, and protects against gate short circuit conditions through VGS monitors. A strong gate pulldown circuit helps prevent unwanted dV/dt parasitic gate turn on events\n\nVarious PWM control modes (6x, 3x, 1x, and independent) are supported for simple interfacing to the external controller. These modes can decrease the number of outputs required of the controller for the motor driver PWM control signals. This family of devices also includes 1x PWM mode for simple sensored trapezoidal control of a BLDC motor by using an internal block commutation table.

DRV8353M

DRV8353M 100-V Three-Phase Smart Gate Driver

DRV8353R

100-VThree-PhaseSmartGateDriver

DRV8353R

100-VThree-PhaseSmartGateDriver

DRV8353R

100-VThree-PhaseSmartGateDriver

DRV8353RF

DRV835xF100-VThree-PhaseSmartGateDriver

DRV8353RFHRGZR

DRV835xF100-VThree-PhaseSmartGateDriver

DRV8353RFSRGZR

DRV835xF100-VThree-PhaseSmartGateDriver

DRV8353RH

100-VThree-PhaseSmartGateDriver

DRV8353RHRGZR

100-VThree-PhaseSmartGateDriver