ACEH25D100G中文資料ACE數(shù)據(jù)手冊(cè)PDF規(guī)格書

Description

The ACEH25D100G is 1M-bit Serial Peripheral Interface (SPI) Flash memory, and supports the Dual SPI:

Serial Clock, Chip Select, Serial Data I/O0 (SI), I/O1 (SO). The Dual Output data is transferred with speed of

108Mbits/s. The device uses a single low voltage power supply, ranging from 2.7 Volt to 3.6 Volt.

Additionally, the device supports JEDEC standard manufacturer and device ID.

In order to meet environmental requirements, offers an 8-pad USON 3x2-mm packages.

Features

? Serial Peripheral Interface (SPI)

Standard SPI: SCLK, /CS, SI, SO, /WP

Dual SPI: SCLK, /CS, IO0, IO1, /WP

? Read

Normal Read (Serial): 55MHz clock rate

Fast Read (Serial): 108MHz clock rate

Dual Read: 108MHz clock rate

? Program

Serial-input Page Program up to 256bytes

? Erase

Block erases (64/32 KB)

Sector erases (4 KB)

Chip erase

? Program/Erase Speed

Page Program time: 0.7ms typical

Sector Erase time: 100ms typical

Block Erase time: 0.3/0.5s typical

Chip Erase time: 8s typical

? Flexible Architecture

Sector of 4K-byte

Block of 32/64K-byte

? Low Power Consumption

20mA maximum active current

5uA maximum power down current

? Software/Hardware Write Protection

Enable/Disable protection with WP Pin

Write protect all/portion of memory via software

Top or Bottom, Sector or Block selection

ACEH25D100G

1M BIT SPI NOR FLASH

VER 1.1 2

? Single Supply Voltage

Full voltage range: 2.7~3.6V

? Temperature Range

Industrial (-40℃ to +85℃)

? Cycling Endurance/Data Retention

Typical 100k Program-Erase cycles on any sector

Typical 20-year data retention at 55℃